Ancel PB100 Circuit Tester Power Probe Automotive Diagnostic Tool 12V 24V Electrical Current Voltage Integrated Power Scanner

Ancel PB100 Circuit Tester Power Probe Automotive Diagnostic Tool 12V 24V Electrical Current Voltage Integrated Power Scanner

UKOBD2 Provide top quality Ancel PB100 Circuit Tester Power Probe Automotive Diagnostic Tool 12V 24V Electrical Current Voltage Integrated Power Scanner, if you need Ancel PB100 Circuit Tester Power Probe Automotive Diagnostic Tool 12V 24V Electrical Current Voltage Integrated Power Scanner, or have any questions about Ancel PB100 Circuit Tester Power Probe Automotive Diagnostic Tool 12V 24V Electrical Current Voltage Integrated Power Scanner, welcome to contact us.

Wholesale Top quality VAS6154, GM Tech2, VCM II For Ford, Porsche Piwis III, USB Link 2, Scania VCI3, CAN Clip, wiTech MicroPod 2, T300 key programmer, locksmith tools

images of Ancel PB100 Circuit Tester Power Probe Automotive Diagnostic Tool 12V 24V Electrical Current Voltage Integrated Power Scanner

Ancel PB100 Circuit Tester Power Probe Automotive Diagnostic Tool 12V 24V Electrical Current Voltage Integrated Power Scanner


ANCEL PB100 Electrical System Circuit Tester Functions:
1. Power injection, measuring, ground testing, polarity checking, continuity testing and component activation.
2. Read the AVO meter, voltage, current, and resistance.
3.Energize the electrical components, such as the cooling fan, relay etc.
4. Activate the components
5. Determine the positive, negative and open circuit.
6. Test the bad ground contacts, follow and locate short circuits without wasting the fuse.
7. Test the continuity of the power switch, relay and diode.
8. Protect the tool from overload.
9. Allow you to work in the dark area by using the built-in head light.
10. Test along the vehicle by the long cable.
ANCEL PB100 Product Function:
1. Work Mode
There are four modes to diagnose the electrical systems,which can be accessed by depressing the Mode Button and cycling through each one.
3. Circuit Continuity Testing in Resistance mode
While the tool is in Resistance mode,using the probe tip with chass is ground or the auxiliary ground lead,continuity can be tested on wires and components attached or disconnected from the vehicle's electrical system.When the probe tip is contacting a good ground,the LCD will indicate"0.0Ω" and green LED wiil be on,A beep tone will sound.
7. Signal Circuit Testing
For example,you suspect there is a problem with your M.A.P.?sensor circuit,then follow the procedure involved with testing this sensor:
Set the tool in AC Voltage mode,using the probe tip with chassis ground or the auxiliary ground lead.
Connect vacuum pump to MAP sensor.
Contact the probe tip to the MAP sensor positive terminal and observe the LCD readings which should be a sine wave in normal condition.
Apply vacuum
Release vacuum and observe the LCD readings

Go to Buy: Ancel PB100 Circuit Tester Power Probe Automotive Diagnostic Tool 12V 24V Electrical Current Voltage Integrated Power Scanner

Tags: Ancel PB100 Circuit Tester
Prev: ANCEL Spark Plug Tester Professional Dual Hole 110V 220V 12V Car Petrol Ignition Analyzer Diagnostic Tool
Next: ANCEL HD3100/HD3200 Heavy Duty Diesel Truck Diagnostic Scanner 12V 24V Car 2 in 1 Full System DPF Pin Detect OBD2 Automotive Truck Scanner