Specification:

1.Operating Mode: Smart and Auto
2.Counts:10000 counts
3.AC Voltage: 0-600V
4.DC Voltage: 0-600V
5.DC Current: 0-10A
6.AC Current: 0-10A
7.Capacitance: 0-10mF
8.Frequency: 50-60Hz
9.Continuity test
10.Fuse alarm
11.Flash light
12.NCV test which quickly identifies neutral and live wires through light intensity
13.Overload protection
14.Safety level: CAT IV 600V/ CAT III 1000V
15.Auto shutdown
16.Battery: 2*1.5V battery(not included)

Third generation digital multimeter-DM100A

One gear can solve all measurements

Third generation multimeter-Smart measure+ Auto range

Application scenario

Intelligent recognition

10000 counts

Vehicle battery measurement

Prepare for your car, it is easy to carry and can spot problems with the car at any time.

Buzzer and continuity

The built-in buzzer sounds continuously and the green indicator lamp lights up when the resistance is less than 15 Ω. The buzzer temporarily emits an alarm and a green control lamp flashes when the measured resistance is between 15 Ω and 30 Ω.

LED lights with high brightness

It's brighter than the LED lights of ordinary multimeters and can work at night too.

Professional capacity measurement

The capacitance is measured quickly (1000uF ONLY about 1 second) and the effect of ESR on the quality of the capacitor can be identified. The measured value is closer to the actual value of the capacitor.

Insert false alarm

If the gear position is incorrect (the gear position and test lead access port do not match) the DM100C screen will display "LEAD" and a beep. For example, if you want to measure voltage, turn the rotary switch to the voltage level. However, if your test lead is connected to the 10A or uA (test current) inlet, a "LEAD" will be displayed.

Fuse disconnected

If the input end fuse is disconnected, the screen will display "FUSE" while the buzzer alarm is triggered.

NCV measurement

High quality test probe

Technical specifications