VVDI RKE BOX Remote Control Switching Box Support 6V/9V/12V

1. Power Options

By default, the device connects to a 3V remote control with no welded joints required.

To connect a 6V, 9V, or 12V remote control, disassemble the main box and select the corresponding welded joints as shown in the image below.

Example: For a 6V remote control, only the 6V welded joints should be connected.

2. Wiring Description

Remove the circuit boards from the original remote control and connect them to the main unit as illustrated in the image on the right: white wire to buttons, red wire to positive, and black wire to negative.

Remote Button Types

The system supports three types of remote buttons:

• 2-feet buttons: No direction distinction; solder each foot separately.
• 4-feet and 5-feet buttons: No direction distinction; must be soldered at diagonal points.

Labels in the wiring diagram:

• Original remote control
• Positive
• Negative
• Remote wiring diagram

IMPORTANT: Do not reverse the power cord on the remote control.

3. Power Supply Options

Power can be supplied via OBD or 12V constant power from the car.

4. Key/Remote Matching and Clearing

Matching Steps

1. Press the SET button on the host box (located in the internal hole on the side of the unit). The buzzer will beep twice, indicating entry into matching mode.
2. Press and hold any button on the new remote until the buzzer beeps continuously. Key matching is now complete.
3. Repeat these steps to add additional remotes.

Matching Notes

• A maximum of six keys can be matched to one host box. Matching will fail if more than six are attempted.
• If no key is detected within 10 seconds during matching mode, the buzzer will beep once and the unit will automatically exit matching mode and return to normal operation.

Clearing Steps

Press and hold the SET button until the buzzer beeps continuously. This clears all previously matched keys and restores the unit to factory settings.

Clearing Note

If a key is lost or no longer needed, erase all keys and re-add only the required ones to maintain security.

Diagram labels:

• Buzzer
• Key to be added
• SET button

5. Adding Key Embryo and Anti-Theft Chip

Instructions for integrating a key embryo and anti-theft chip into the remote control are supported by the system.

Package Includes

• 1pc × VVDI RKE BOX
• 2pc × key